Skip to content
Ships from Florida · Free US ground shipping on orders $500+
Product helpCart (0)
Home > Replacements P120

Replacements P120

Replacement flap strips in grit P120 come as 28-strip sets for the re-flappable QuickWood hub. Pick your flap height below (45mm standard or 65mm tall), then choose width and grit on the product page — every grit from P60 to P320 is in stock.

Flap Replacement - 45mm Height - QuickWood Replacement Flaps - 45mm, Fits Your Existing Hub $45.00+ Flap Replacement - 65mm Height - QuickWood Replacement Flaps - 65mm, Flexible Trim Refill $56.00+

When to use P120 flap strips

P120 is the most-loaded grit in most wood shops: fine enough to leave hardwood ready for stain, coarse enough to erase the scratch pattern left by P80 and P100. If you buy one grit for general raw-wood sanding of profiles, curves and shaped parts, buy P120.

Before and after P120

P120 follows P100 in a full sequence, or opens the job on wood that machined cleanly. Step to P150 for a finer stain-ready surface, or stop here for most paint-grade and darker-stain work. Between finish coats, move to P180 and finer — P120 is too coarse for a sealed surface.

Fitting these strips

Each set is 28 strips for the re-flappable QuickWood hub in 45mm standard or 65mm tall trim; the taller trim reaches profiles deeper than about 1.5 inches. Refill sets run roughly 60% less than a complete wheel, and the same hub takes every grit from P60 to P320. Project-by-project examples are in the grit guide.