Skip to content
Ships from Florida · Free US ground shipping on orders $500+
Product helpCart (0)
Home > Replacements P320

Replacements P320

Replacement flap strips in grit P320 come as 28-strip sets for the re-flappable QuickWood hub. Pick your flap height below (45mm standard or 65mm tall), then choose width and grit on the product page — every grit from P60 to P320 is in stock.

Flap Replacement - 45mm Height - QuickWood Replacement Flaps - 45mm, Fits Your Existing Hub $45.00+ Flap Replacement - 65mm Height - QuickWood Replacement Flaps - 65mm, Flexible Trim Refill $56.00+

When to use P320 flap strips

P320 is the finest grit in the range: final-coat denibbing, thin waterborne finishes, and any pass where the goal is silk rather than stock removal. At this grit the wheel is barely cutting — it is refining, which is exactly what you want on the last coat before rub-out or delivery.

Where P320 belongs

Use P320 after P240 in a waterborne schedule, or as the only between-coats grit on very thin films where even P240 feels aggressive. It has no role on raw wood — below the sealer line, stop at P180. Light pressure is everything at this grit: the flap tips should whisper across the surface.

Fitting these strips

28-strip sets for the re-flappable hub in 45mm standard or 65mm tall trim. Because P320 strips wear their sharpness slowly at finishing pressure, a set lasts a long time in between-coats service — and the cleaning stick pulls finish load out of the flaps to stretch them further. Full schedule guidance is in the grit guide.