Skip to content
Ships from Florida · Free US ground shipping on orders $500+
Product helpCart (0)
Home > Replacements P240

Replacements P240

Replacement flap strips in grit P240 come as 28-strip sets for the re-flappable QuickWood hub. Pick your flap height below (45mm standard or 65mm tall), then choose width and grit on the product page — every grit from P60 to P320 is in stock.

Flap Replacement - 45mm Height - QuickWood Replacement Flaps - 45mm, Fits Your Existing Hub $45.00+ Flap Replacement - 65mm Height - QuickWood Replacement Flaps - 65mm, Flexible Trim Refill $56.00+

When to use P240 flap strips

P240 is the between-coats specialist: after sealer or the first finish coat has dried, a light P240 pass knocks down raised grain and dust nibs and leaves a surface the next coat can bond to — without cutting through on profile crowns the way a hard pad does. This is the grit that makes brush sanding worth having in a finishing room.

Choosing between P240 and its neighbors

Under lacquer and oil finishes, P180 to P240 covers the between-coats work; under thin waterborne finishes reach for P240 to P320. Pressure matters more than grit here: let the flap tips flick across the surface — leaning in folds the flaps and burnishes instead of cutting.

Fitting these strips

28-strip sets for the re-flappable QuickWood hub, 45mm standard or 65mm tall trim for deep profiles. A finishing-room hub loaded with P240 and swapped to P320 for final coats covers most schedules. The grit guide has the full between-coats walkthrough.